Where to start….

Today, I had the wonderful pleasure of spending the day with Lyric Kinard as a part of a two day “Surface Design Sampler Platter” workshop.   We went full tilt for 6-1/2 hours with about 20 minutes for lunch.  Over the next few posts I will try to show what we did, but I wanted to start out with my favorite…..stamp carving!!!!

We used white rubber erasers as our palette and started out by sketching out a few designs…..

We used these drawings as rubbings to transfer the design to the eraser….

….and then started cutting, first with an X-Acto knife……

….and then adding some details with a linoleum carving tool.  The most fun thing to do was to cut a circle.  The technique included inserting the knife point at an angle into the eraser.  You then turned the eraser in a circle until the knife arrived back at the starting point.

The circle popped out easily!!!!

My second design (cut on the other side of the eraser) was done almost entirely with the Lino-tool

Now came the moment of truth….what would this look at when printed!!!

We used a foam brush to pat the paint onto the stamp…..

 

and….VOILA…… HOW MUCH FUN IS THIS!!!!!

Lyric has a “signature” fabric where everyone places their stamp and then signs.  It was fun to see all of the designs that have come out of her workshops…..

Well, there is one technique…..we also did beading, screen printing, foiling, and image transfer…..and there is still another day to come!!!!

More later…..