A Touch or Two of Red

Yesterday I shared the centerpiece to the “down the rabbit hole” quilt that I started……

Now it was time to add some borders. My first thought was to add a 2-inch red border…..

….but it was apparent that 2-inch was too wide. So, let’s look at my 1.5-inch red strips…..

I chose to cut them into various sizes, ranging from 2-inch to 4-inch…..

The nice thing about doing various sizes is that you don’t have to worry about ANYTHING matching up, and that is always a good thing!!

I sewed them into couplets…..

…..quadruplets……

….and kept stitching until I had one strip long enough for all four sides…..

I chose not to iron this strip until I had finished all of the piecing. While ironing, I tugged lightly at the strip to be sure that it stayed straight in the pressing process…..

Now I was ready to attach the borders. Some people spend a lot of time measuring and cutting but my process is a bit easier. Here it is…..

First I lay the border strips down the middle of the top……

…..and trim the borders to fit the top…..

Now both border pieces are the exact same size.

Next I mark the center of one border strip and match it up to the middle of one side of the top, and pin in place…..

Next, move to a far corner and pin the strip in place…..

Repeat for the other side…..

Now I look at the area between the two pins. In this case you can see that there is more fullness in the red border than in the quilt top……

This is where we can laud the stretchy qualities of cotton fabrics!!! I slightly tugged the fabrics so that the two edges lined up and then I held them in place with a pin…..

When it comes time to sew, I work between the pins, again stretching the fabrics slightly if needed……

After pressing both borders out……

…..you start the process over again with the other two borders…..

Quick as a flash, the first border was on…….

Now what will I add for the outside???

I won’t have time to work on it again for a while, so I will have plenty of time to figure that out!!

.

.